Duffy 214 Instructions

Instructions for other spaces can be found here.

The Extron Wall Panel operates:

  • Video projector

  • Input for the projector  

  • Volume controls (projector must be on to hear audio)

Note: Projector must be on to hear audio.

Turn Projector On

  1. At the control panel, under Display, press the ON button on the Extron panel.  The light on the projector will turn on.   
  2. Please wait 45 seconds while the projector is warming up. Do not press any buttons on the panel for 45 seconds.

Display Laptop

  1. Connect the VGA cable or HDMI cable to your laptop. Please note, if you are using a Mac laptop, you may need to use your VGA adaptor.  If you need audio from your laptop, please connect the audio cable to the headphone jack on your laptop.

  1. Connect the other end of the VGA cable or HDMI cable to the connection in the cubby hole at the end of the table.

      3. Turn on your laptop. 

      4. On the control panel, press the VGA or HDMI button, depending upon your source, and the laptop image should display on the screen.

Troubleshooting Laptop Display                                

If you do not get a picture on both your laptop and the projector screen.

  • Windows - hold down the following laptop keys simultaneously. The “Windows” key located on the bottom left of the keyboard and the letter "P" key, and make sure the setting is set to "Duplicate"
  • Mac OS X - navigate to System Preferences > Displays > Arrangement and then check off Mirror Displays.

Shut Down

  1. At the control panel, under Display, press the OFF button on the Extron panel.   The display OFF light will flash while the projector cools down. NOTE: You will not be able to restart the system until the projector cools down (and the OFF light stops flashing). This will take approximately 2 minutes.

Was this helpful?
0 reviews


Article ID: 58692
Tue 7/31/18 3:00 PM
Wed 8/2/23 12:08 PM